We use cookies to optimize our website for you and to be able to continuously improve it. By continuing to browse the site you are agreeing to our use of cookies.
Disagree
126.771 used machines
Model
- DFS 2/2(1)
- DH 315 x 3-III / TGL 30-2332(1)
- DH250x3-III(1)
- DKRD Ø 160 mm(1)
- DLZ 500 IV L 1000(1)
- DP 4000 DP 5000(1)
- DP1/S2(1)
- Dreibackenfutter(1)
- Durchmesser 200 mm(8)
- Durchmesser 250 mm(5)
- TGL30-2312 Ø 160 mm(1)
- ZKX 400(1)
- Ø 1400 x 2000 mm(1)
- Ø 200 mm(3)
- Ø 250 mm(1)
approved
dealer
dealer
Three-jaw chuck, three-jaw lathe chuck, 3-jaw chuck -Mouth size: Ø 250 mm -Recess: Ø 210 mm -Passage: Ø 80 mm -Weight: 20.7 kg
approved
dealer
dealer
Three-jaw chuck, three-jaw lathe chuck -Chuck size: Ø 250 mm -one set: hard interchangeable jaws -Passage: 81 mm -Rezess: Ø 210 mm -Hole circle: Ø 230 mm -Weight: 19 kg
approved
dealer
dealer
Three-jaw chuck, three-jaw lathe chuck, 3 jaw chuck -Chuck size: Ø 250 mm -Short taper: 6 -Throughout: Ø 80 mm -Weight: 25.9 kg
approved
dealer
dealer
max. width of grinding wheel: 50 mm ratio: 0 max. dia. of grinding wheel: 400 mm total power requirement: 3 kW weight of the machine ca.: 1000 kg dimensions of the machine ca.: m Pre-Dressing Device for Gear Grinding Wheels The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
approved
dealer
dealer
Face plate diameter: 1.250mm Center height above foundation slab: 1,250mm Weight: 19t Power: 55Kw Max. torque on the face plate: 31,500Nm Maximum workpiece mass between centres: 16,000 kg Speed range: 2.24 – 224 rpm
approved
dealer
dealer
Parallel Lathe WMW NILES type DLZ 500 IV L 1000 Between points: 1000 mm Maxi Ø on bench: 500 mm Maxi Ø over saddle: 300 mm Spindle diameter: Ø 50 mm Spindle speed: from 28 to 1400 RPM 3-jaws chuck Ø 200 mm Threadings: Metric + Whitworth Tailstock CM4 Auto Feeds transverse + longitudinal + rapid Lubricant pump Voltage: 380 V Dimensions (L x W x H): 3000 x 1400 x 1500 mm Weight: approx 2,5 T
approved
dealer
dealer
centre distance: 5000 mm turning diameter over bed: 4000 mm turning dia. in gap: 5000 mm spindle bore: 104 mm turning speeds: 1,4 - 71 (18x) U/min total power requirement: 30 kW weight of the machine ca.: t dimensions of the machine ca.: m 4-jaw face plate Ø 3.150 mm modular lathe! The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.
