D Printers FARSOON eForm

Laser printer for plastics FARSOON eForm 3D built in 2017. The printer is offered with complete equipment for preparing powder and cleaning prints. The equipment was used to a small extent for about 12 months, it worked for about 2000 hours. The device operated in a gas shield from a cylinder.

Complete with printer: 8 nitrogen regulators.

Technical data of the FARSOON eForm 3D printer:
- open control software: any modification of printing parameters
- laser type: CO?
- laser power: 30 W
- dimensions of the printing chamber (W × D × H ) : 250 × 250 × 320 mm
- single print layer: 0.06 ~ 0.3 mm, adjustable
- maximum creation / build speed: 0.8 l / h (depending on the material)
- precise scanning system: Galvo
- scanning speed: 7.6 m / s
- power requirements: 380 VAC, 50/60 Hz, 16 KVA, three-phase five-wire
- maximum temperature in the chamber: 190 degrees C
- heating element: golden infrared heater
- thermal field control: 8-zone heater and intelligent temperature control systems
- temperature regulation, continuous monitoring and optimization of surface temperature in real time
- 64-bit operating system: Windows 7
- user interface mode: exchangeable expert mode and production mode
- system control software: FarsoonMakeStar, open platform control interface
- data M5751405 file format: STL
- the M5751405 most important software functions: manual and automatic mode, modification of compilation parameters in real time, three-dimensional visualization, diagnostic functions
- printer dimensions (W × D × H ) : 1735 × 1225 × 1975 mm

Additional equipment
- external chiller: INDUSTRIAL CHILLER CW 6000

Material (plastic) used in powder form:
- FS 3300PA (powder based on PA1212)
- FS 3401GB (filled with glass ball)
- FS 3400CF (filled with carbon fiber)
- FS 3250MF (filled with mineral fiber)
- FS 4100PA (powder PA11)
seller offer No. resale 143413043